一种多狭缝条纹变相管

设计了一种动态范围大、小型化条纹变相管,其时间分辨能力在2.6 ps左右,变相管的长度为196.532 mm,可以工作在单狭缝和多狭缝模式下,使得这种条纹变相管不但可以应用在激光核聚变、等粒子物理、激光技术、光生物、光化学等传统的超快诊断领域内,而且可以应用于海底探测以及空中预警等领域,可获得高速运动目标的三维空间+一维强度信息的探测.     

Parameters to Define the Electron Beam Trajectory of a Double-Tapered Disc-Loaded Wideband Gyro-TWT in Profiled Magnetic Field

In the method of tapering the cross section of the interaction structure for broadbanding a gyro-TWT, the different portions of the interaction length of the tapered-cross-section waveguide become effective for different frequency ranges if the magnetic field and beam parameters are profiled to maintain the condition of electron cyclotron resonance throughout the interaction length. In the present paper, the study of profiling the magnetic field and beam parameters in steps of the stepped analytical model of a double-tapered disc-loaded circular waveguide was made throughout the steps of the model. In the observed profile, the magnetic flux density in a typical step relative to its value in first-step decreases from first-step (gun-end) to end-step (collector-end) of the model considering the up-tapering schemes, in which structure parameters increase from gun-end to collector-end. Also, the transverse beam velocity in a typical step relative to its value in first-step decreases from gun-end to collector-end. However, the Larmor radius in a typical step relative to its value in first-step as well as the hollow-beam radius in a typical step relative to its value in first-step, both increase from gun-end to collector-end in the model considering the up-tapering schemes.     

管内变密度流体的充分发展流动与换热

本文提出了圆管内变密度流体流动与换热充分发展的概念及其相关假设.在所提出的概念和假设基础上给出了摩擦阻力系数Cf与Nusselt数Nu的定义式和计算式.通过对圆管内密度随温度变化的氩气的流动与换热所进行的数值模拟,验证了在本文的计算条件范围内,圆管内变密度流体充分发展流动与换热的概念是合理的,并且CfRe=16,Nu=4.36.     

多波段条纹管激光成像系统探测距离计算

基于条纹管激光成像的基本原理，分析了利用条纹管实现紫外到近红外波段激光成像的技术可行性，并对其性能进行了分析；建立了激光成像雷达方程，计算了不同波长在不同天气条件下的探测距离，并分析了各激光波长的应用领域和优缺点．     

轴角编码器测量中偏心带来的误差分析

介绍了应运多面体和自准直光管组合测量高准确度编码器角度的原理和方法，具体分析了多面体中心和编码器轴中心偏心时对测量角度产生的测量误差，并对自准直光管光轴和多面体中心、编码器轴中心两者偏心连线不重合时产生的测量误差进行了分析，同时对两中心偏心的方向进行了判定．实验证明，多面体中心与编码器轴中心不重合时对测量将产生按正弦或余弦规律变化的系统误差，同时自准直光管光轴和两者中心连线不重合对测量结果将不会产生影响．     

纳米科技研究中的若干新热点

讨论了纳米科技在各个领域不同于常规材料的优越性和它在各个范畴内的研究热点 ,了解它的发展趋势。     

Study of the membrane effect on turbulent mixing measurements in shock tubes

The effect of the thin membrane on the time evolution of the shock wave induced turbulent mixing between the two gases initially separated by it is investigated using two different sets of experiments. In the first set, in which a single-mode large-amplitude initial perturbation was studied, two gas combinations (air/SF and air/air) and two membrane thicknesses were used. The main conclusion of these experiments was that the tested membrane has a negligible effect on the evolution of the mixing zone, which evolves as predicted theoretically. In the second set, in which similar gas combinations and membrane thicknesses were used, small amplitude random-mode initial perturbation, caused by the membrane rupture, rather than the large amplitude single-mode initial perturbation used in the first set, was studied. The conclusions of these experiments were: (1) The membrane has a significant effect on the mixing zone during the initial stages of its growth. This has also been observed in the air/air experiment where theoretically no growth should exist. (2) The membrane effect on the late time evolution, where the mixing zone width has reached a relatively large-amplitude, was relatively small and in good agreement with full numerical simulations. The main conclusion from the present experiments is that the effect of the membrane is important only during the initial stages of the evolution (before the re-shock), when the perturbations have very small amplitudes, and is negligible when the perturbations reach relatively large amplitudes. Received 29 August 1998 / Accepted 25 December 1998     

偏二甲肼渗透管标准物质的制备及其均匀性稳定性研究

以精馏和光解纯化工艺获得的高纯偏二甲肼为原料,制备了渗透率范围为0.5-30μg/min的偏二甲肼渗透管标准物质.经过均匀性、稳定性检验,结果表明:该标准物质均匀性、稳定性良好,为航天作业环境中各类快速检测仪的监控准确性提供了判定依据.     

非对称阻力元件抑制直流的实验研究

简要分析了双向进气型脉冲管制冷机中存在的直流现象及其抑制措施;使用所研制的两台非金属同轴脉冲管制冷机,通过测量其蓄冷器外壁温度分布的方法,实验验证了基于闭合回路的固有直流的方向;通过分析其降温曲线及对冷头最低无负荷温度的影响,验证了可以利用非对称阻力元件产生相反方向的附加直流以消除系统中的固有直流,从而取得较好的制冷效果。实验对其效果进行了量化分析。